Brown Metals can offer the following specifications. Material is certified to the latest specification revision in most instances.

Temper	Annealed	Quarter Hard	Half Hard	Full Hard
Alloy
301	-	AMS-5517 ASTM-A-666	AMS-5518 ASTM-A-666	AMS-5519 ASTM-A-666
302	AMS-5516 ASTM-A-240 ASTM-A-666	AMS-5903 ASTM-A-666	AMS-5904 ASTM-A-666	AMS-5906 ASTM-A-666
304	AMS-5513 ASTM-A-240 ASTM-A-666	AMS-5910 ASTM-A-666	AMS-5911 ASTM-A-666	AMS-5913
304L	AMS-5511 ASTM-A-240 ASTM-A-666	-	-	-
305	AMS-5514 ASTM-A-240	-	-	-
316	AMS-5524 ASTM-A-240 ASTM-A-666	-	-	-
316L	AMS-5507 ASTM-A-240 ASTM-A-666	-	-	-
321	AMS-5510 ASTM-A-240	-	-	-
410	AMS-5504 ASTM-A-240	-	-	-
430	AMS-5503 ASTM-A-240	-	-	-
17-7	AMS-5528 ASTM-A-693	-	-	Condition "C" AMS-5529 ASTM-A-693
C1010	ASTM-A-109	-	-	#1 Temper ASTM-A-109

Cancellation Notices & Notes For Other Specifications

Specification	Comments
MIL-S-5059	MIL-S-5059 was cancelled effective September, 1993. This specification covered a variety of alloy/temper combinations. The AMS specifications should be used as replacements for MIL-S-5059.
QQ-S-766	QQ-S-766 was cancelled effective July, 1993. It has been replaced by the ASTM specifications listed in the table above. Use the following guidelines for requesting the correct replacement specification: Cold Worked Grades (Tempered): ASTM-A-666 Precipitation Hardening Grades (17-7): ASTM-A-693 Other grades, including Annealed (soft): ASTM-A-240
MIL-S-25043	MIL-S-25043 was cancelled effective May, 1997. This specification was specific to the 17-7 grade. The corresponding AMS specifications in the table above are to be used as replacements for MIL-S-25043.
AMS-5515	AMS-5515 is the specification for 302 Annealed with a Carbon (C) content of .08 - .15. Brown Metals Company purchases material to meet both 302 / 304. Because 304 has a maximum Carbon (C) reading of .08, we are not able to certify to AMS-5515. All 302 / 304 material at Brown Metals Company will have a Carbon reading LESS THAN .08.

Specifications, cancellation notices, and other documents can be obtained by contacting Document Engineering (1-800-MIL-SPEC).